How Long Does an HVAC System Last? What Homeowners Should Know

what-does-5000-btu-mean

Wondering how long your HVAC system should last? Learn the average lifespan of AC units, furnaces, and heat pumps, and the signs it’s time to replace. Your HVAC system quietly keeps your home comfortable through sweltering St. Louis summers and bitter Midwest winters. But like any major piece of equipment, it won’t run forever. Knowing …

Read more

Why Is My AC Running But Not Cooling?

ac-not-turning-on

AC running but not cooling your home? Learn the most common causes, troubleshooting tips, and when to call for AC repair in St. Louis. When your air conditioner is running, but your home still feels warm, it can be frustrating—especially during the hot, humid St. Louis summer. You may hear the system operating and feel air coming …

Read more

Trane Heat Pump Troubleshooting — Not Heating, Defrost Issues, Fault Codes

Heat Pump Installation St. Louis

Trane heat pumps provide both heating and cooling from a single outdoor unit, making them an efficient choice for St. Louis homeowners. But when a heat pump stops working properly — especially in heating mode — diagnosing the problem requires understanding how heat pumps work differently from conventional furnaces and air conditioners. This guide covers …

Read more

Trane Furnace Short Cycling — Causes, Diagnosis, and Fixes

Furnace Repair St. Louis

Short cycling — when your Trane furnace turns on, runs for a few minutes, shuts off, and then starts the cycle again — is one of the most common and damaging furnace problems. The furnace never completes a full heating cycle, your home stays cold, and the repeated starts put excessive wear on the heat …

Read more

Trane Furnace Won’t Ignite — No Heat Diagnosis and Repair Guide

gas-smell-from-furnace

When you call for heat and nothing happens — the furnace starts but never lights, or the burners ignite briefly and then shut off — you have an ignition failure. On Trane furnaces, this typically triggers a 2-flash fault code after the control board has attempted and failed ignition three times. This guide walks through …

Read more

Trane Furnace Pressure Switch Fault — 3-Flash Code Diagnosis and Repair

Furnace Repair St. Louis

A 3-flash fault code on a Trane furnace indicates a pressure switch fault — specifically, the pressure switch failed to close (or opened unexpectedly) during a heating cycle. This is one of the most common Trane furnace fault codes, and it has several possible causes ranging from a blocked vent (a 5-minute fix) to a …

Read more