Short cycling — when your Trane furnace turns on, runs for a few minutes, shuts off, and then starts the cycle again — is one of the most common and damaging furnace problems. The furnace never completes a full heating cycle, your home stays cold, and the repeated starts put excessive wear on the heat …
When you call for heat and nothing happens — the furnace starts but never lights, or the burners ignite briefly and then shut off — you have an ignition failure. On Trane furnaces, this typically triggers a 2-flash fault code after the control board has attempted and failed ignition three times. This guide walks through …
The flame sensor is a small but critical component in your Trane furnace — and it is one of the most common causes of furnace problems. A dirty or failed flame sensor causes the furnace to light and then shut off within seconds, usually with a 8-flash fault code (low flame signal) on the control …
Trane gas furnaces use a diagnostic LED on the control board to communicate fault codes through a series of blinks. When something goes wrong, the LED flashes a specific pattern — a number of rapid blinks followed by a pause — that points to the cause of the problem. Understanding what these codes mean can …